What is the point of that truck if ain’t even able to use it for it’s intended purpose?
I was never into trucks, but a cascade of circumstances put me in one. I hate to admit it, but I love that damn thing. I’m always throwing shit in the back, taking more camping trips, more wilderness trips, fishing low pressure spots, hauling trailers of shit, it does everything. The only thing that could come close utility wise would be a minivan, though I’d lose the offroad capability. I don’t love the gas mileage, but I’m looking at a possible ethanol conversion.
All that to say, if you have a truck, use it like a truck.
Doing an ethanol conversion will only get you worse gas mileage btw. Ethanol contains 25% less energy than gasoline by volume, so you need to burn more of it to make the same power.
That’s a big reason while I’m on the fence. There’s a lot of conflicting information regarding actual costs and pollution. If I can determine that overall costs are reduced, even with the lowered gas mileage, and the exhaust pollutants being reduced, then I’ll do it. As it stands, I haven’t seen anything that appears definitive.
Ethanol has been in use in Brazil since the 70s. The fuel is cheaper than gasoline, but you need to burn more of it. The rule of thumb was that the break even point was around 70% the price of gasoline (but that was applicable to the mostly compact car fleet of Brazil - every vehicle would have its own number).
It definitely pollutes significantly less. You also have zero issues with carbonization in the motor as alcohol has a decent detergent action. You should get a bit more life out of your catalytic converter.
You get a few “free” HP if the conversion is done right.
Cold mornings are your enemy. Alcohol takes longer to heat up your engine, so there’s a gasoline reservoir for cold starts that the on-board computer doses until the engine is warm enough to not sputter out.
If your conversion leaves you with a flex motor (any mixture of gas and ethanol), you can switch to E25 in high winter (or eyeball it at the pump for something like 50/50). Helps avoid wasting fuel heating the engine from a cold start when it’s white out.
Ethanol is highly hygroscopic, so components in your gas train that don’t deal well with water can start to rust. This was an issue mostly in the days of leaded gas, but nowadays all gas has some ethanol in it, so you’re probably fine.
So, this is something I’ve also wondered. My main use for a truck is pulling the camper to the mountain, but I’ve heard that putting premium fuel just before your trip will help you, but that does not make sense as premium fuel is less volatile because it’s meant for higher compression rates in more performance tuned engines.
Correct, don’t use premium fuel unless your engine requires it.
Amen. I grew up in rural Ontario where everyone and their kid has either a pickup truck or a beat up old Cutlass. I yearn to have a pickup because of how awesome they are. Challenge is I live in suburbia. It doesn’t make sense and I can’t justify it. People really need to think critically more about their purchases.
Same here, and the added benefit that you can throw whatever shit on the back without a real care of damaging it, and then just hosing it down. On an SUV or Minivan I would be making sure that everything was clean or carefully covered so not to spill on the carpet and shit.
Pavement princess
I work in the freight industry and I handle the dock pickups basically all day, this kind of crap happens all the time
Literally people tell me not to scratch the rhino liner all the damn time, it’s annoying
Do you tell them to get a real work vehicle? Gotta get to their ego I reckon
Usually I show them how far my forklift can place their freight without scooting it (which is never far enough (only when they complain about the potential for scratches)) then mention, “Unfortunately without scooting it you’ll have to load this by hand.”
Usually this gets them to relent and then I get to show them how tough the lining is by scooting the freight and not damaging anything
Sometimes though they still don’t want it scooted so they end up having to load it by hand by themselves (I can’t help by hand as it’s a liability thing) which always brings a smile to my face
Literally today some dingus ended up loading 5000lbs of flooring into their F-550 by hand because they didn’t want the rhino lined bed scratched
Edit: I accidentally a word
The hell…I have a pickup with bedliner that we use (in part) for picking up pellets for our pellet stove by the ton. They put the pallet on as far as they can while it’s fully on the forks, then lift up the end of it and push the pallet on to the truck the rest of the way. No issues at all, and we’ve been doing it for several years now.
I throw all kinds of crap on it. A few years ago we were getting rid of fencing the previous owners had left…the only thing I had to worry about was them tangling enough that I wouldn’t be able to get another piece in (we have a cap on our truck). That’s the whole point in getting the bedliner. I’d refuse to help someone doing that.
why the hell did they bother to put rhinoloner then? That’s wild i can’t believe there are people that think this way.
Hey now, don’t make fun of the mentally challenged
This is glorious, thanks for sharing.
wtf is wrong with our society…
But it’s rhino liner. Isn’t that what it’s meant for?
People are so superficial.
One day my friend told me not to grab any tools on the way to a junkyard, as they had everything we would need already loaded.
Later on, they didn’t want me using said tools because they were new and might get scratched or the ratchet gears damaged. Kinda wanted to punch him in his idiot mouth.
Mate, I’d punch him too.
I treat my tools well and even baby the fancy ones a bit. But god damn, they’re fking tools, they’re meant to be used and eventually everything breaks.
A friend’s somewhat classic car has a tire change kit and we get a flat tire, they don’t want to have the change kit show any wear, so we end up waiting hours for roadside assistance to come change a tire… not with the included tire though.
Punch 'em.
eventually everything breaks
Not good tools! I have tools that were my great grandfather’s, and they still work perfectly.
deleted by creator
I have been in that exact position before. The hard cover was locked and the keys for it disappeared somewhere on the job site. We needed the piece of crown moulding to finish a job we were working on so we did exactly what you see in the photo.
Should the keys not be on the fob with the key to operate the vehicle?
Aftermarket hard top that locked into the top of the tailgate. You could unlock the tailgate but wouldn’t be able to pull it down.
If memory serves me the hardtop keys were given to someone to get a tool and never returned to the driver.
This is why vans are superior to trucks.
Unless you are carrying chemicals constantly and don’t want to be smelling the fumes all day.
My renault came with a solid steel cargo barrier and small glass window. You could carry a lion in the back and probably be fine.
You would trust your lungs to vehicle manufacturers getting every van air-tight with seals to last for many years?
because they eliminate the margin case of losing your aftermarket hardtop keys?
Both have their use cases. I wouldn’t say one is better than the other
Millions upon millions of contractors in every country except the US would disagree
Of course they would because they don’t need one for what they do. But I also imagine another few million around the world do. What you choose depends on what you need
Except they can’t do the one other key function of a truck.
Tow
Vans can tow too. Many full sized Vans are a truck chassis and drivetrain with the body of a Van.
vans always have a much lower tow rating, the chassis and drivetrain are almost always different in some critical way
There are vans that can tow 3500kg trailers. With a payload in the van.
Apples to apples, those vans are more expensive and larger. At what point does it become ok to have an open bed? There are valid pros and cons in every choice being talked about, here.
At what point does it become ok to have an open bed?
When the distance from the back of the truck to the front of the bed is longer than the distance from the back of the cab to the front of the truck, it turns from a Sport Utility Truck into a Pickup Truck. Typically that’s around when the bed gets big enough to haul a sheet of plywood or drywall safely.
Of course it’s OK to have an SUT instead of a pickup truck, just not as useful for construction work.
They mean that the key should be on the same keychain as the ignition key.
Nah, those guys are truck jousters, on the way to face off with their arch enemies
btw
You giving them way too much credit
His friend only shares the cab but not the bed
Doesn’t want his buddy to scratch up the lininng of the bed.
TBF, some people put carpeted interiors on their truck beds, idk why
He brought the hard wood for nothing.
A wagon could fit that
I like the look of these new long bed minivans.
Short bed, watcha gonna do??
What did he say dear?
He said…
DIAGONALLY
Removed by mod
