deleted by creator
deleted by creator
touch the tip of the solder where the iron meets the pad or the pin
try to get as much contact with both the pad as the pin as you can
the pad could be dirty or not hot enough. Especially when the pad is connected to a ground or power plane layer in the PCB it may take longer than expected to reach a sufficient temperature. Usually adding some flux helps remove any dirt.
Thanks for the update and your hard work!
It’s cheddar cheese with some common, food safe chemicals that help suspend extra water in the cheese to make it melt easier and stringy-er. So it’s basically cheese.
Did something change? Last time I bought an album on Qobuz i could download the whole thing in a single zip file. This was quite a while ago though
Similar setup here, as a bonus I also connected my jellyfin to Listenbrainz to get recommendations and some sweet stats.
Yea you are? Sprinters or Crafters easily fit a stack of sheets, at least in the EU they do