Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.
What brand?
deleted by creator
All of them.
Kenmore
Can less
Barbieless
There is a screwdriver that you can get at the hardware store for this type of screw. You shouldn’t have to, I definitely agree. But fuck ‘em, repair your shit with the $5 screwdriver.
Comon, do some reading:
They didn’t have to cut shit.
Which was discovered AS RESULT of cutting open.
You are quite spammy, aren’t you?
No, the shaft was not uncovered as a result of cutting the thing open. They were able to reach the screw-head with a regular screw-driver, just not turn it. Says right there in the post.
Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.
You are quite spammy, aren’t you?
No, the shaft was not uncovered as a result of cutting the thing open. They were able to reach the screw-head with a regular screw-driver, just not turn it. Says right there in the post.
Learn to read, stop spamming people with your shit takes, and sure, let’s pretend replying to your copy-pasted bullshit with more copy-pasted bullshit is somehow worse. Anything to feed trolls like you.