• Someology@lemmy.world
    link
    fedilink
    English
    arrow-up
    45
    arrow-down
    3
    ·
    1 year ago

    If you have a poor quality, low density (often mass produced), ceramic plate, there are tiny air bubbles inside it. These vibrate when the microwave runs, heating the plate faster/more than the food. This is the same reason why some mug handles get hot enough for 2nd or 3rd degree burns in the microwave while others never get the “microwave handle of death”. Better made ceramics will have far fewer (or none) of these bubbles. This is why usually hand made pottery will not heat up like this, while factory stuff that was quickly poured into molds often will.

    • Misconduct@startrek.website
      link
      fedilink
      arrow-up
      7
      ·
      1 year ago

      Often is a stretch. Plenty of the cheap mass produced stuff still doesn’t heat up at all. It’s almost exclusively older stuff that I notice heating up these days

    • AlotOfReading@lemmy.world
      link
      fedilink
      arrow-up
      5
      ·
      1 year ago

      That’s not how RF works. For one thing, microwaves run at 2.4GHz, which means they can’t “see” physical features smaller than a few centimeters (to greatly oversimplify what’s going on). The miniscule bubbles simply aren’t a big factor.

      Rather, what’s happening is that the ceramic (probably the glaze if we’re honest) has a higher cross section and/or lower specific heat than the food, especially when it’s frozen. It absorbs more energy and heats up faster.

      I would also expect far fewer and smaller bubbles with industrial slip casting (“pouring into a mold”) than manual production.

      • Someology@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        I just know that stoneware dishes that I have hand made and fired ( wedging the air out of the clay extremely well) do not ever have this problem, but the light weight, aerated slip cast stuff from mass market stores often does. It cuts across all colors and types of glazes. It really very much seems to be the density of the clay the vessel is made from, which is just another way to say, how aerated it is. The same thing is also observable when it is a dish I have hand made and fired from porcelain, which is why I’ve assumed it is technique/physical construction and not the actual clay or glaze type. Perhaps instead it is the amount of total vitrification of the clay, which would also affect the density of the finished vessel as well.