• GrindingGears@lemmy.ca
    link
    fedilink
    arrow-up
    26
    ·
    edit-2
    1 month ago

    There’s a couple things that I would like to point out here. I am a Tesla owner, not a huge fanboi or anything, but this is another press example of trying to incite fear.

    One: this vehicle was travelling over 200km/hr. It hit a cement barrier. That car could have been made of bubble wrap, it wasnt going to be pretty, no matter what.

    Two: there is, in fact, a mechanical override latch in Tesla doors. You pull up on the latch at the top of the panel. It looks like a door handle. In fact, most people who are first riders in my car, end up pulling it before they realize there’s a door button there. Which is a pain in the ass because the door window doesn’t automatically roll down when it closes and it can damage the seals. But yeah, there’s a mechanical latch right there for the pulling.

    Also there’s other vehicles that have the exact same door systems, but the press also neglects to ever mention that. Corvettes are one that comes immediately to mind.

    Again not totally a Tesla fanboi, I bought it before Elon went off the deep end. I do like the car though. Don’t hit shit at 200km/hr or drunk drive into ponds, and you are generally fine.

    • AstralPath@lemmy.ca
      link
      fedilink
      arrow-up
      15
      ·
      1 month ago

      Thanks for the insight. I still want to voice my opinion that the window design is bad and Tesla and any other manufacturer using that design should feel bad.

      I had a 2007 Subaru Impreza with frameless windows. There was no need to to worry about the window when closing the door. It simply made a pressure seal against the doorframe gasket.

    • Vodulas [they/them]@beehaw.org
      link
      fedilink
      arrow-up
      8
      ·
      1 month ago

      The front latch is fine, but the rear one is a wire behind a piece of trim you have to remove (unless that has changed). The passengers in the rear would have to know where it was and how to use it. In an emergency, the likelihood of being able to do that is pretty low.

      • 🇰 🌀 🇱 🇦 🇳 🇦 🇰 ℹ️@yiffit.net
        link
        fedilink
        English
        arrow-up
        9
        ·
        edit-2
        1 month ago

        Having worked at the plant in Fremont: The design has probably changed multiple times just in the past month. They were constantly making small little changes to the way various things were put together so that not even a single batch of cars made in the same day would necessarily be exactly the same design. It was one of the few cool things about how they operate.

        Safety of the workers in the plant worked the same way. Some dude biffed his forklift and almost took me out with his long-ass load. Managers and safety people were on the scene in less than 5 minutes and already laid out new rules for the forklifts about how long their loads could be to prevent it happening again.

      • GrindingGears@lemmy.ca
        link
        fedilink
        arrow-up
        4
        ·
        1 month ago

        It’s sort of changed. There’s a big bend in the rubber now (which the passengers strangely think is a door handle), and it is an obvious grab point. Underneath is the panel, but it’s not one that you have to grab with your fingernails anymore, it’s got a big red tab that pops right off with the littlest pressure, exposing the wire. To me it’s fairly obvious, but I still think there should be a mandatory sticker on the panel. It’s not the greatest system either, but it exists whereas these news articles are trying to shape the narrative that it doesn’t (just like when that lady drunk drove into the pond). Probably isn’t the worst idea to ditch the rubber in the pocket over the override, that part is pretty stupid and doesn’t really serve a purpose anyways.

        • Vodulas [they/them]@beehaw.org
          link
          fedilink
          arrow-up
          3
          ·
          1 month ago

          For sure needs to be more obvious/put a sticker on it, and this still doesn’t excuse the driver. If other cars are doing the same thing they should be getting the same coverage, but Tesla gets clicks.

    • DarthYoshiBoy@beehaw.org
      link
      fedilink
      arrow-up
      7
      ·
      1 month ago

      this vehicle was travelling over 200km/hr. It hit a cement barrier. That car could have been made of bubble wrap, it wasnt going to be pretty, no matter what.

      The car looked like this after burning to a crisp. That’s a survivable wreck any day of the week (assuming seatbelts and airbags were in working order) but of course for the burning. The story says they hit a guard rail and eventually a cement pillar. Given the image, it doesn’t look like it was a head on collision and the passenger compartment is still in its original shape, so they were not likely to have been doing 200 kph by the time they hit the cement pillar. Guard rails (and I know this from experience with an unfortunate black ice incident that harmed nobody) will slow a car down quite a bit in not a whole lot of time, they’re not just there for show. My experience totalled the car, but it saved my whole family’s life by getting us down from 65 mph to 0 mph safely and in a very short period of time. It was shocking to see how short the deceleration had been once we drove past it in the daylight the following day and saw the tiny marks in the shoulder and the railing from our crash.

      Crucially, one of the occupants of this Tesla crash did in fact survive, which makes it pretty clear what the survivability of the crash was. The fact is that people on the scene couldn’t get the car open from the outside and people that probably would have had a chance at otherwise being saved, burned to a crisp. You can say that the 125mph made it so they were doomed any way you look at it, but there were rescuers on the scene trying to get people out and the one person they managed to get out did in fact survive, so it’s probably disingenuous to claim that the battery fire and egress issues didn’t have anything to do with the deaths.

      I’m not anti EV. My primary ride is an EV these days and I love it enough to say that everyone should drive an EV if they can manage, but claiming that the speed involved meant anyone in any vehicle would have met the same fate is probably not squaring with the reality here. The rescuer who saved the one passenger was surprised later that 4 other people had died, he claimed that it was hard to see other passengers in the car because of the thick smoke inside. I’m not saying that standard mechanical door handles would have saved the day for those 4, but it certainly seems like the lack thereof didn’t help, the battery fire component certainly made a bad situation worse, and the Model Y’s “unbreakable” laminate glass windows probably also pushed the equation more towards deadly than dangerous. I’ll admit that the press loves to bag on an EV, but there are legit dangers with battery damage and Tesla isn’t doing any favors for addressing them by making manual egress more difficult than it has to be with their design choices.

      • GrindingGears@lemmy.ca
        link
        fedilink
        arrow-up
        1
        ·
        edit-2
        1 month ago

        Just one thing I’d like to point out, it looks like that, sure. Notice how it’s missing the entire B pillar? That didn’t burn off, they had to do extensive cutting.

        Also this is how it looked from a side view: https://toronto.citynews.ca/2024/10/24/four-dead-electric-vehicle-crash-toronto/amp/

        The accident was at high speed. That car is mangled. This is the press making a very big deal out of facts that aren’t entirely straight (there’s no way to open the doors manually! - when there is), and it’s heavily reliant on the words of a 74 year old man who’s feeding into this. It’s definitely food for thought, but it’s also a lot of hysteria. That car is hella bent, the doors probably weren’t opening regardless of the door mechanisms, and yeah EVs require a different approach to fighting their fires. Fossil fuel powered cars burn too, eh? And they can be a real bitch to put out as well, people burn alive in them too.

        Regardless of the arguments, it sucks that people had to die here. I think it speaks well to the safety of the vehicle though, that someone survived. I do agree on the glass, but there’s a whole lot of vehicles that use that type of glass, so again Tesla takes the beating meanwhile half the manufacturers today use it. Everyone wants whisper quiet interiors, so that sound insulation has to come from somewhere.